9/19/2022 Price increase necessary. Materials costs gone crazy. Handcrafted wall display case with Plexiglass Front Cover. Front cover slides down smartly in special grooves from the top. (See note below) Upper piece of trim attached to the Plexiglass blends in with and matches rest of the trim when docked in position. Extra protection for your collection with the rich walnut wood look! Economical design adds minimal cost and durability. No hinges, knobs or clasps to loosen or break. Most of the added cost is the plexiglass itself requiring minimum modification of the standard case design. Frame is made of wood, STAINED WALNUT, with 1/8 hardboard interlocking slats creating 108 compartments which hold standard 1/64 scale hot wheels or matchbox cars. It has a 1/8 hardboard backing and is open in front after raising plexiglass cover. Each compartment is 3 1/4″w by 1 13/16″h by 1 3/4d. Overall dimensions of the case is 32″w x 24″h x 2d. Keyholes in the back are spaced on 16″ centers (for stud mounting) and 8″ from each side allowing multiple cases to be wall mounted side by side and still keep stud settings. Stud mounting is not necessary as wall anchors and screws are included. This design provides a rich, decorative way to display your valuable collections. I try to always keep cases in stock but when inventory runs out this listing ends until I have time to rebuild it. Thank you for looking and look forward to your order! NOTE: COVER CAN BE MADE TO BE REMOVED BY LIFTING UP ONLY 1 AND THEN STRAIGHT OUT THE FRONT. IF YOU DESIRE THIS CONFIGURATION JUST SEND A NOTE WITH YOUR ORDER REQUESTING THE “MODIFIED COVER”.